Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
Fog/Driving Lamp Bulb: Service and Repair
Front Fog Lamp
Removal
BULB
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. Reach into the front wheel house ahead of the front wheel to unsnap and lift the cover over the access hole in the front of the wheel house splash
shield.
4. Reach through the access hole in the splash shield to access the back of the front fog lamp housing on the back of the fascia.
5. Disconnect the wire harness connector from the fog lamp socket (1).
6. Firmly grasp the socket on the back of the housing and rotate it (2) counterclockwise about 30 degrees to unlock it.
7. Pull the socket and bulb straight out from the keyed opening in the housing.
8. Pull the base of the bulb straight out of the socket.
Installation
BULB
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
