Commander 4WD V6-3.7L (2009)
3. Install shaft (1) on transfer case flange (2).
4. Install bolts to transfer case flange (2) and tighten bolts to 32 Nm (24 ft. lbs.).
5. Install transmission crossmember.
Rear
INSTALLATION
NOTE: Clean all propeller shaft bolts and apply Mopar(R) Lock & Seal Adhesive or equivalent to the threads before installation.
NOTE: Inspect propeller shaft boot for damage and replace if necessary.
1. Install propeller shaft (1) on transfer case (2) or transmission (3) with reference marks aligned. Install flange bolts and tighten to 108 Nm (80 ft.
lbs.).