Commander 4WD V6-3.7L VIN K (2007)
Garage Door Opener Transmitter: Programming and Relearning
Erasing Transmitter Codes
ERASING TRANSMITTER CODES
NOTE: Individual channels cannot be erased. Erasing the transmitter codes will erase ALL programmed codes.
To erase programming from the three buttons (individual buttons cannot be erased but can be "reprogrammed" - note below), follow the step noted:
-
Press and hold the two outer HomeLink(R) buttons and release only when the Electronic Vehicle Information Center (EVIC) display shows
"Channels Cleared" (after 20 seconds). Release both buttons. Do not hold for longer that 30 seconds. HomeLink(R) is now in the train (or
learning) mode and can be programmed at any time.
Programming Transmitter Codes
PROGRAMMING TRANSMITTER CODES
Programming Common Transmitter Codes
WARNING: Vehicle exhaust contains carbon monoxide, a dangerous gas. Do not run the vehicle's exhaust while training the transceiver.
Exhaust gas can cause serious injury or death.
WARNING: Your motorized door or gate may open and close while you are training the Universal Transceiver if the vehicle is in range of the
motorized device. Do not train the transceiver if people or pets are in the path of the door or gate. A moving door or gate can cause serious
injury or death to people and pets or damage to objects.
NOTE: When programming a garage door opener, it is advised to park outside the garage. It is also recommended that a new battery be placed in the
hand-held transmitter of the device being programmed to HomeLink(R) for quicker training and accurate transmission of the radio-frequency signal.
The Electronic Vehicle Information Center (EVIC) features a driver-interactive display which includes HomeLink(R) system messages. The EVIC is
located in the upper part of the cluster between the speedometer and tachometer.
1. Press and hold the two outer HomeLink(R) buttons (5), and release only when the EVIC display shows "Channels Cleared" (after 20 seconds).
Do not hold the buttons for longer than 30 seconds and do not repeat step one to program a second and/or third hand-held transmitter to the
remaining two HomeLink(R) buttons.
2. Position the end of your hand-held transmitter 1-3 inches (3-8 cm) away from the HomeLink(R) buttons.
3. Simultaneously press and hold both the HomeLink(R) button that you want to train and the hand-held transmitter buttons. Do not release the
buttons until step 4 has been completed.
NOTE: Some gate operators and garage door openers may require you to replace this Programming Step 3 with procedures noted in the "Gate
Operator/Canadian Programming" section.
4. The EVIC display will show "Channel X Training" (where X is Channel 1, 2, or 3). Release both buttons after the EVIC display shows
"Channel X Trained".
NOTE: If the EVIC display shows "Did Not Train" repeat steps 2-4.