Commander 4WD V6-3.7L VIN K (2007)
Radiator: Removal and Replacement
Removal
GAS ENGINES
WARNING: Do not remove the cylinder block drain plugs or loosen the radiator draincock with the system hot and under pressure. Serious
burns from coolant can occur. Refer to cooling system draining.
Do not waste reusable coolant. If the solution is clean, drain the coolant into a clean container for reuse.
CAUTION: When removing the radiator or A/C condenser for any reason, note the location of all radiator-to-body and radiator-to-A/C
condenser rubber air seals. These are used at the top, bottom and sides of the radiator and A/C condenser. To prevent overheating, these seals
must be installed to their original positions.
1. Disconnect the negative battery cable at battery.
2. Drain coolant from radiator.
3. Remove the front grille.
4. Remove two radiator mounting bolts.
5. Disconnect both transmission cooler lines from radiator.
6. Disconnect electrical connector for the fan control solenoid.
7. Disconnect the power steering cooler line from cooler and filter.
8. Disconnect the radiator upper and lower hoses.
9. Disconnect the overflow hose from radiator.
10. Remove the air inlet duct at the grille.
