Commander 4WD V6-3.7L VIN K (2007)
Air Door Actuator / Motor: Service and Repair
Controls - Rear
Removal
REMOVAL
1. Remove rear HVAC housing (1) and place it on a workbench.
2. Disconnect the rear HVAC wire harness connector (2) from the rear blend door actuator (3).
3. Remove the two screws (4) that secure the rear blend door actuator to the back of the rear HVAC housing and remove the actuator.
Installation
INSTALLATION
1. Position the rear blend door actuator (1) onto the back of the rear HVAC housing (2). If necessary, rotate the actuator slightly to align the splines
on the actuator output shaft (4) with those in the rear blend door pivot shaft (3).