Commander 4WD V6-3.7L VIN K (2007)
HOUSING-AIR DISTRIBUTION
NOTE: The air distribution housing must be removed from the HVAC housing and disassembled for service of the mode-air and blend-air doors.
1. Install the upper defrost/panel-air door (1), lower defrost/panel-air door (2), directional vane (3) and the blend-air door (4) into the left side air
distribution housing (5) as required. Align the air doors with the pivot shaft holes in the housing.
2. Install the upper defrost/panel-air door (1), lower defrost/panel-air door (2), directional vane (3), rear outlet-air door (4) and the blend-air door (5)
into the right side air distribution housing (6) as required. Align the air doors with the pivot shaft holes in the housing.
3. If removed, align the front floor-air doors (1 and 3) with each other and install then into the center partition (2). Make sure that the air door
retaining tabs (4) are fully engaged.