Commander 4WD V6-3.7L VIN K (2007)
Front HVAC Housing
HOUSING-HVAC ASSEMBLY
CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system. Failure to properly adjust the refrigerant
oil level will prevent the A/C system from operating as designed and can cause serious A/C compressor damage.
NOTE: When replacing multiple A/C system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be added to
the refrigerant system.
NOTE: If the A/C evaporator is being replaced, add 60 milliliters (2 fluid ounces) of refrigerant oil to the refrigerant system. Use only refrigerant oil
of the type recommended for the A/C compressor in the vehicle.
1. If removed, install the insulator (3) over the A/C evaporator (2). If the seal is deformed or damaged, it must be replaced.
2. If removed, install the rubber seal (1) into the lower half of the HVAC housing (4). If the seal is deformed or damaged, it must be replaced.
3. Install the A/C evaporator into the lower half of the HVAC housing. Make sure that the evaporator drain within the HVAC housing is clean and
unrestricted and that the insulator and rubber seal are properly installed.
4. Install the upper half of the HVAC housing (3) onto the lower half of the HVAC housing (4) and fully engage the two plastic retaining clips (7).
5. Install the ten screws (6) that secure the two halves of the HVAC housing together. Tighten the screws to 2.2 Nm (20 in lbs.).
6. Install the three metal retaining clips (5) that secure the two halves of the HVAC housing together.
