Commander 4WD V6-3.7L VIN K (2007)
17. Install the air inlet housing (2) onto the HVAC housing (1).
18. Install the air distribution housing (3) onto the HVAC housing.
19. Install the HVAC housing assembly.
20. If the A/C evaporator is being replaced, add 60 milliliters (2 fluid ounces) of refrigerant oil to the refrigerant system. When replacing multiple
A/C system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be added to the refrigerant system. Use
only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
Rear HVAC Housing
ASSEMBLY
CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system. Failure to properly adjust the refrigerant
oil level will prevent the A/C system from operating as designed and can cause serious A/C compressor damage.
NOTE: When replacing multiple A/C system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be added to
the refrigerant system.
NOTE: If the rear A/C evaporator is being replaced, add 30 milliliters (1 fluid ounce) of refrigerant oil to the refrigerant system. Use only refrigerant
oil of the type recommended for the A/C compressor in the vehicle.
1. Install the blend-air door (1) and the mode-air door (4) onto the pivots located in the inboard half of the rear HVAC housing (3).
2. Install the rear A/C evaporator (2) into the inboard half of the rear HVAC housing.
