Commander 4WD V6-3.7L VIN K (2007)
Headlamp Bulb: Service and Repair
Installation
Boot - Headlamp Bulb
BOOT - HEADLAMP BULB
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
1. Position the low beam (upper) or high beam (lower) boot (2) to the back of the front lamp unit housing.
2. Push the inner circumference of the boot down and around the bulb collar formation on the back of the lamp reflector as necessary to fully engage
the boot to the reflector.
3. Push the outer circumference of the boot down and around the boot collar formation on the back of the lamp housing as necessary to fully engage
the boot to the housing.
4. Reinstall the low or high beam headlamp bulb into the front lamp unit.
5. Reinstall the front lamp unit onto the front of the vehicle.
Bulb - Headlamp
BULB - HEADLAMP
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
NOTE: The following procedure applies to both the low beam (upper) and the high beam (lower) headlamp bulbs. The service procedures for each bulb
are the same, only the bulb location, size and type differ.
