Commander 4WD V6-3.7L VIN K (2007)
-
Headlamp Optical Horn - The left multi-function switch control stalk includes momentary switching of the headlamp high beam circuits to
provide an optical horn feature (sometimes referred to as flash-to-pass), which allows the vehicle operator to momentarily flash the headlamp high
beams as an optical signalling device.
-
Park Lamps - The left multi-function switch control knob provides detent switching for the park lamps.
-
Rear Fog Lamps - For vehicles so equipped, the left multi-function switch control knob provides detent switching for the optional rear fog lamps.
Rear fog lamps are optional only for vehicles manufactured for certain markets, where they are required.
-
Turn Signal Control - The left multi-function switch control stalk provides both momentary non-detent switching and detent switching with
automatic cancellation for both the left and right turn signal lamps.
The left multi-function switch also provides the vehicle operator with a control interface for the following interior lighting functions:
-
Interior Lamps Defeat - The left multi-function switch control ring provides detent switching to DEFEAT the illumination of all interior courtesy
lamps when a door, the rear flip-up glass, or the liftgate are opened.
-
Interior Lamps On - The left multi-function switch control ring provides detent switching to simultaneously illuminate all interior courtesy
lamps.
-
Panel Lamps Dimming - The left multi-function switch control ring provides simultaneous adjustable control of the illumination intensity of all
instrument panel lighting at one of six available illumination intensity levels.
-
Parade Mode - The left multi-function switch control ring provides detent switching for a PARADE mode that maximizes the illumination
intensity of all instrument panel lighting for visibility when driving in daylight with the exterior lamps turned ON.
The left multi-function switch cannot be adjusted or repaired. If any function of the switch is ineffective, or if the switch is damaged, the entire switch
unit must be replaced.