Commander 4WD V6-3.7L VIN K (2007)
Turn Signal Cancel Cam: Service and Repair
Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Position the alignment hole in the turn signal cancel cam (3) over the alignment pin (4) of the clockspring rotor on the back of the Steering Control
Module (SCM) housing (1).
2. Using hand pressure, press the cam firmly and evenly onto the rotor until each of the three latch features of the cam is fully engaged.
3. Reinstall the SCM onto the steering column.
