Commander 4WD V6-3.7L VIN K (2007)
NAG1 Transmission Fill Graph
6. Check transmission oil temperature using the appropriate scan tool.
NOTE: The true transmission oil temperature can only be read by a scan tool in REVERSE or any forward gear position.
7. Determine the height of the oil level on the dipstick and using the height, the transmission temperature, and the Transmission Fluid Graph,
determine if the transmission oil level is correct.
8. Add or remove oil as necessary and recheck the oil level.
9. Once the oil level is correct, install the dipstick tube cap.
Transmission Fill
TRANSMISSION FILL
To avoid overfilling transmission after a fluid change or overhaul, perform the following procedure:
1. Verify that the vehicle is parked on a level surface.
2. Remove the dipstick tube cap.
3. Add following initial quantity of Mopar(R) ATF +4, Automatic Transmission Fluid, to the transmission:
a. If only fluid and filter were changed, add 7.0 L (7.4 qts.) of transmission fluid to transmission.
b. If the transmission was completely overhauled or the torque converter was replaced or drained, add 8.1 L (17.1 pts.) of transmission fluid to
transmission.
4. Check the transmission fluid and adjust as required.