Commander 4WD V6-3.7L VIN K (2007)
Electronic Brake Control Module: Service and Repair
Removal
REMOVAL
1. Remove the negative battery cable from the battery.
2. Install a brake pedal prop rod.
3. Siphon the master cylinder.
4. Disconnect the HCU electrical connectors (5).
5. Remove the primary brake line at the master cylinder.
6. Remove the primary brake line from the HCU (4).
7. Remove the secondary brake line at the master cylinder.
8. Remove the secondary brake line at the HCU (4)
9. Remove the 4 chassis lines (3) at the HCU (4).
10. Remove the 1 mounting nut and 1 bolt holding the HCU bracket attachment to the vehicle.
11. Remove the HCU (3) with the bracket (5) from the vehicle.