Commander 4WD V6-3.7L VIN K (2007)
8. Position the seat belt lower anchor (2) to the buckle bracket on the outboard side of the right center seat support bracket. Be certain that the belt
webbing is not twisted between the top of the seat back and the lower anchor.
9. Install and tighten the screw (3) that secures the lower anchor to the right center seat support bracket. Tighten the screw to 50 Nm (37 ft. lbs.).
10. Restore the right outboard second row seat to its seating position.
Second Row Outboard
SECOND ROW OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Be certain that the retractor shield (1) is properly installed in the inner C-pillar and in good condition before installing the retractor.
2. Position the second row outboard seat belt (4) and retractor (7) to the lower C-pillar as a unit.
3. Engage the locator tab on the back of the retractor into the slot in the lower C-pillar.
4. Install and tighten the screw (5) that secures the retractor to the lower C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
5. Position the seat belt turning loop (2) to the upper C-pillar (1). Be certain the seat belt webbing between the retractor and the turning loop is not
twisted.
6. Install and tighten the screw (11) that secures the seat belt turning loop to the upper C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
