Commander 4WD V6-3.7L VIN K (2007)
Fluid - Transfer Case: Service and Repair
NV140 Transfer Case
STANDARD PROCEDURE - FLUID DRAIN/REFILL
1. Raise vehicle.
2. Remove the bolts (1) holding the damper (2) to the rear case (3).
3. Remove the damper (1) from the rear case (2).
NOTE: The fill (2) and drain (3) plugs are both in the rear case.
4. Position drain pan under transfer case.
5. Remove drain and fill plugs and drain lubricant completely.
6. Install drain plug. Tighten plug to 20-34 Nm (15-25 ft. lbs.).
7. Remove drain pan.
8. Fill transfer case to bottom edge of fill plug opening with the required fluid.
9. Install and tighten fill plug to 20-34 Nm (15-25 ft. lbs.).
