Commander 4WD V6-3.7L VIN K (2007)
Seals and Gaskets: Service and Repair
NV140 Transfer Case
Seal-Front Output Shaft
REMOVAL
The front output shaft seal and wear sleeve cannot be serviced in the vehicle. The transfer case must be disassembled to remove the front output shaft
assembly and seal.
Removal
REMOVAL
1. Remove the rear propeller shaft.
2. Using Holder C-3281 (1), remove the rear companion flange (2) nut.
3. Remove the rear output flange (1) from the main shaft (2). If necessary, use a suitable 2 or 3 jaw puller to remove the output shaft flange.
4. Remove the rear output seal with a suitable pry tool or a screw mounted in a slide hammer.
Installation
INSTALLATION