Commander 4WD V6-3.7L VIN K (2007)
11. Re-prime any area that is not fully and evenly primed.
CAUTION: Always apply the bead of adhesive to the quarter glass. Always install the quarter glass within 5 minutes after applying the
adhesive.
NOTE: If the original urethane adhesive has been exposed for more than 12 hours, the entire adhesive area will need to be re-primed prior to
installing new adhesive.
12. Apply approximately a 10 mm (0.4 in.) wide bead of adhesive with a triangular nozzle approximately 6 mm (0.230 in.) from the edge of the glass
starting at the bottom center of the quarter glass.
13. Run the end of the adhesive bead on the quarter glass parallel to the start of the bead and smooth the ends flush.
14. Place the quarter glass into the window opening (2) and insert mounting studs through the holes in the window fence.
15. Install the headliner.
16. Install the quarter panel trim. Refer to Trim Panel.
