Commander 4WD V8-4.7L (2008)
Parking Assist Control Module: Service and Repair
Installation
INSTALLATION
1. Position the park assist module (1) into the cavity on the left outboard end of the intermediate step assembly (3) and insert the two mounting tabs
on the rear side of the module into the slots in the back of the cavity.
2. Slide the module toward the rear of the intermediate step cavity, then push downward on the front of the module until the two latch features
integral to the cavity are fully engaged over the mounting tabs on the front (connector) side of the module.
3. Reconnect the underbody wire harness connector (2) to the module connector receptacle. Vehicles with the front park assist option will have a
second connection to the module at this location, which must also be reconnected.
4. Reinstall the carpeted cover panel over the cavity on the left outboard end of the intermediate step assembly.
5. Restore the left outboard second row seat assembly to its normal seating position.
6. Reconnect the battery negative cable.
