Commander 4WD V8-4.7L VIN N (2006)
2. Align and insert the sensor into the sensor bracket (3) on the back of the rear bumper fascia (4) until the bracket latch features are fully engaged
over the top and bottom tabs of the sensor. Be certain that the sensor membrane is flush with the outer surface of the fascia.
NOTE: Be certain that each sensor membrane is properly centered in the openings of the rear fascia and that the O-ring spacers are not pinched.
Improper centering or pinched O-rings can be detrimental to proper park assist sensor operation.
3. From the back of the fascia, reconnect the wire harness connector to the sensor connector receptacle.
4. For the two inboard rear park assist sensors only, reinstall the bumper fascia onto the rear of the vehicle.
5. Reconnect the battery negative cable.
