Commander 4WD V8-4.7L VIN N (2006)
Garage Door Opener Transmitter: Reading and Clearing Diagnostic Trouble Codes
ERASING TRANSMITTER CODES
NOTE: Individual channels cannot be erased. Erasing the transmitter codes will erase ALL programmed codes.
To erase programming from the three buttons (individual buttons cannot be erased but can be "reprogrammed" - note below), follow the step noted:
-
Press and hold the two outer HomeLink(R) buttons and release only when the Electronic Vehicle Information Center (EVIC) display shows
"Channels Cleared" (after 20 seconds). Release both buttons. Do not hold for longer that 30 seconds. HomeLink(R) is now in the train (or
learning) mode and can be programmed at any time.
