Commander 4WD V8-4.7L VIN N (2006)
Radio Receiver: Service and Repair
WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag, or instrument panel
component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions
could result in accidental airbag deployment and possible personal injury.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Fold and tumble the right outboard second row seat assembly forward.
3. Remove the carpeted cover panel from over the cavity on the right outboard end of the intermediate step assembly.
4. Remove the mounting fasteners.
5. Disconnect the antenna and electrical harness connectors.
6. Remove the module.
INSTALLATION
1. Connect antenna and electrical harness connector to module.
2. Install the receiver module.
3. Install and tighten mounting fasteners.
4. Install the carpeted cover panel from over the cavity on the right outboard end of the intermediate step assembly.
5. Connect battery negative cable.
