jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Body - Lower Door Hinge Chirp/Squeak/Groan|Page 7764 > < Body - Lower Door Hinge Chirp/Squeak/Groan|Page 7762
Page 2
background image

SYMPTOM/CONDITION:
The lower door hinges make a moderate to loud popping/groan sound when the door is opened or closed.

This is due to the roller axle not being properly maintained with grease.

DIAGNOSIS:
Open the doors and listen for the popping or groan sound from the lower hinge, if the sound is present perform the Repair Procedure.

PARTS REQUIRED:

REPAIR PROCEDURE:

1. Open door.

2. With straw installed on the lithium grease spray can (p/n 04318066AB), spray a very small amount of grease between the roller pin and inside roller

surface (axle). (Fig. 1).

CAUTION:

Be careful not to spray grease on the outside of the roller or roller cam. If grease is allowed to get on the outside of the roller or roller cam it must be
cleaned off using a clean shop towel. Grease left on the outside of the roller and roller cam may also cause a noise.

3. Open and close the door 10 times to work the grease onto the roller axle.

4. Wipe away any excess grease in the sprayed area.

5.

Repeat steps 1 through 4 for every door.

POLICY:
Reimbursable within the provisions of the warranty.

Body - Lower Door Hinge Chirp/Squeak/Groan|Page 7764 > < Body - Lower Door Hinge Chirp/Squeak/Groan|Page 7762