Commander 4WD V8-4.7L VIN N (2006)
DIAGNOSIS:
Open the doors and listen for the popping or groan sound from the lower hinge, if the sound is present perform the Repair Procedure.
PARTS REQUIRED:
REPAIR PROCEDURE:
1. Open door.
2. With straw installed on the lithium grease spray can (p/n 04318066AB), spray a very small amount of grease between the roller pin and inside roller
surface (axle). (Fig. 1).
CAUTION:
Be careful not to spray grease on the outside of the roller or roller cam. If grease is allowed to get on the outside of the roller or roller cam it must be
cleaned off using a clean shop towel. Grease left on the outside of the roller and roller cam may also cause a noise.
3. Open and close the door 10 times to work the grease onto the roller axle.
4. Wipe away any excess grease in the sprayed area.
5.
Repeat steps 1 through 4 for every door.
POLICY:
Reimbursable within the provisions of the warranty.
