Commander 4WD V8-4.7L VIN N (2006)
8.
Verify that the window glass run channel is properly attached to the inner door panel. Tighten the upper nut and the lower screw to 10 N-m (90 in.
lbs) (Fig. 3).
9.
Verify that the glass run channel weatherstrip is fully seated to the glass run channel. Adjust as required.
10.
Inspect the window regulator operation, glass, regulator glass clamp and pad, and adjust the glass position.
a.
Install the negative battery cable to the battery.
b.
If the glass is already loose from the window regulator clamps, slide the glass to the full up position and temporarily tape glass in place.
c.
Carefully position (raise) the window regulator for access to the two glass clamp bolts. Loosen the 10 mm bolt at each window regulator
glass clamp. Temporarily tape in the full up position, any glass that was previously attached to the regulator glass clamps.
d.
Position (lower) the window regulator so that two regulator glass clamps can be thoroughly inspected.
