Commander 4WD V8-4.7L VIN N (2006)
5. Remove the mid-conduit clip and door harness clip prior to regulator removal.
6. Remove the bolts (1 and 3) that secure the window regulator rails to the inside of the door.
7. Lower the regulator rails within the door far enough to access and disconnect the wire harness connector (5) from the regulator motor through the
large access hole in the center of the door and remove the regulator.
INSTALLATION
1. Load the window regulator (4) into the front door through the large access hole in the center of the door and connect the wire harness connector
(5) to the regulator motor.
2. Engage the three bolts (1) into the keyed holes (2) on the inside of the door.
3. Install the two bolts (3) that secure the bottom of the regulator rails to the door. Tighten the bolts to 10 N.m (90 in. lbs.).
4. Tighten the bolts that secure the regulator rails (4) to the three keyed holes (2) on the inside of the door. Tighten the bolts to 10 N.m (90 in. lbs.).
