Commander 4WD V8-4.7L VIN N (2006)
1. Position the rear door hinge onto the door.
NOTE: If the epoxy bonded washers are separated from the door hinges, the door may need to be adjusted.
2. If removed, install the epoxy bonded washers (1).
3. Loosely install the nuts (4) that secure the hinges to the rear door.
4. Align the hinges to the door using the reference marks made during the removal procedure and tighten the nuts to 31 N.m (23 ft.lbs).
5. Carefully position the rear door to the body and support the door with a suitable lifting device.
6. Loosely install the five bolts (1 and 4) that secure the rear door hinges (2 and 3) to the B-pillar.
7. Align the rear door to the body using the reference marks made during the removal procedure and tighten the bolts to 28 N.m (21 ft.lbs).
8. Connect the rear door wire harness to the body wire harness.
9. Reconnect the negative battery cable.
10. If necessary, adjust the rear door.
