Commander 4WD V8-4.7L VIN N (2006)
1. Install a new clip into the door at the mirror flag.
2. Position the door trim panel near the front door and connect the door wire harness connectors (2) to the power door switch assembly connectors
(1).
3. Connect the interior door handle actuator rod (3) to the interior door handle (4) and engage the retainer.
4. Lift the trim panel (1) over the inside of the door far enough to engage the interior door latch lock link and knob into the hole at the upper rear
corner of the trim panel and into the inner belt seal.
5. Position the trim panel to the inside of the door and fully engage the eight plastic door trim panel retention clips (3) to the door.
6. Install the three screws (2) that secure door trim panel to the door. Tighten the screws to 2 Nm (16 in. lbs.).
7. Reconnect the negative battery cable.
Liftgate Sill Scuff Plate
PLATE-LIFTGATE SCUFF
REMOVAL
