Commander 4WD V8-4.7L VIN N (2006)
1. Route the seat belt through the access door opening in the lower B-pillar trim panel.
2. Position the lower B-pillar trim panel to the B-pillar and engage the retaining tabs that secure the trim panel to the B-pillar.
3. Install the upper B-pillar trim panel.
4. Position the seat belt lower anchor to the mounting hole on the outboard side of the front seat cushion frame. Be certain that the seat belt webbing
between the turning loop and the lower anchor is not twisted.
5. Install the screw (2) that secures the lower anchor to the seat. Tighten the screw to 39 N.m (29 ft.lbs).
6. Reinstall the lower anchor cover (1) onto the front seat cushion outboard side shield.
