Commander 4WD V8-4.7L VIN N (2006)
INSTALLATION
1. Route the seat belt (3) through the slot in the upper C-pillar trim panel (1).
2. Position the locating tabs on the bottom of the upper C-pillar trim panel into the slots in the top of the quarter trim panel (2).
3. Rotate the top part of the trim panel into position and install the screw.
CAUTION: The upper trim plug must be removed and discarded to gain access to the upper retaining screw before attempting to
remove the trim panel. Failure to remove the trim screw may result in damage to the trim panel or the retaining clip.
4. Install a new trim plug (1) into the trim panel.
