Commander 4WD V8-4.7L VIN N (2006)
3.
Evaluate the paint condition.
4.
DA surface with 600 grit sand paper.
5.
Clean with appropriate solvent per paint supplier recommendations.
6.
Feather edge the damaged areas.
7.
Apply corrosion resistant primer to bare metal spots if they exist.
8.
Spot prime with primer surfacer.
9.
Block sand the primer surfacer.
10.
Final sand per paint suppliers recommendations.
11.
Clean with appropriate solvent.
12.
Tack off the repair area.
13.
Apply basecoat with appropriate hardener per paint supplier recommendations.
14.
Allow flash time per paint suppliers recommendations and tack off area.
15.
Apply clear coat per paint suppliers recommendations.
16.
Detail vehicle as required.
INSTALL LIFTGATE HANDLE:
1.
Install the liftgate handle on the vehicle. Refer to the detailed installation procedures available in DealerCONNECT > TechCONNECT under:
Service Info > 23 - LIFTGATE > HANDLE > HANDLE INSTALLATION.
2.
Connect the negative battery cable.
3.
Set the clock to the proper time.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
Technical Service Bulletin # 23-003-06
Date:
060119
Body - Paint Etching Repair
