Commander 4WD V8-4.7L VIN N (2006)
PARTS REQUIRED:
SPECIAL TOOLS/EQUIPMENT REQUIRED:
REPAIR PROCEDURE "A" FINESSE:
1.
Clean with Mopar Car Wash Concentrate, and water.
2.
Wipe with an alcohol based cleaner
3.
Evaluate the paint condition.
4.
Measure and record paint film thickness in areas to be sanded using an electronic mil gauge (PSE).
5.
Use 2000 grit sand paper mounted to a ridged backer to remove all etching.
6.
If you remove more than 0.5 mil of clear coat you will need to refinish using repair procedure "B" refinish.
7.
If refinishing is not required polish sanded areas using Mopar Compound Power Cleaner # BSMM8432.
8.
Remove swirl marks using Mopar Swirl Free polish # BSMM8232.
9.
Detail vehicle as required.
REPAIR PROCEDURE "B" REFINISH:
1.
Clean with Mopar Car Wash Concentrate, and water.
2.
Wipe with an alcohol based cleaner
3.
Evaluate the paint condition.
4.
DA surface with 600 grit sand paper.
5.
Clean with appropriate solvent per paint supplier recommendations.
6.
Feather edge the damaged areas.
7.
Apply corrosion resistant primer to bare metal spots if they exist.
8.
Spot prime with primer surfacer.
9.
Block sand the primer surfacer.
10.
Final sand per paint suppliers recommendations.
