Commander 4WD V8-4.7L VIN N (2006)
8.
Remove swirl marks using Mopar Swirl Free polish #BSMM8232.
9.
Detail vehicle as required.
REPAIR PROCEDURE "B" REFINISH:
1.
Clean with Mopar Car Wash Concentrate, and water.
2.
Wipe with an alcohol based cleaner
3.
Evaluate the paint condition.
4.
DA surface with 600 grit sand paper.
5.
Clean with appropriate solvent per paint supplier recommendations.
6.
Feather edge the damaged areas.
7.
Apply corrosion resistant primer to bare metal spots if they exist.
8.
Spot prime with primer surfacer.
9.
Block sand the primer surfacer.
10.
Final sand per paint suppliers recommendations.
11.
Clean with appropriate solvent.
12.
Tack off the repair area.
13.
Apply basecoat with appropriate hardener per paint supplier recommendations.
14.
Allow flash time per paint suppliers recommendations and tack off area.
15.
Apply clear coat per paint suppliers recommendations.
16.
Detail vehicle as required.
INSTALL LIFTGATE HANDLE:
1.
Install the liftgate handle on the vehicle. Refer to the detailed installation procedures available in DealerCONNECT > TechCONNECT under:
Service Info > 23 - LIFTGATE > HANDLE > HANDLE INSTALLATION.
2.
Connect the negative battery cable.
3.
Set the clock to the proper time.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
