Commander 4WD V8-4.7L VIN N (2006)
Brake Master Cylinder: Service and Repair
Master Cylinder
MASTER CYLINDER
REMOVAL
1. Siphon the master cylinder.
2. Remove the primary brake line (6) at the master cylinder.
3. Remove the secondary brake line (6) at the master cylinder.
4. Disconnect the brake fluid level switch (7) from the master cylinder.
5. Remove the 2 master cylinder mounting nuts (8).
6. Remove the master cylinder.
INSTALLATION
NOTE: Bleed new master cylinder on bench before installation.
1. Install the master cylinder with new gasket and nuts (8).
2. Reconnect the brake fluid level electrical connector (7).
3. Install the secondary brake line (6) at the master cylinder.
4. Install the primary brake line (6) at the master cylinder.
5. Fill and bleed brake system.