Commander 4WD V8-4.7L VIN N (2006)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
HCU (HYDRAULIC CONTROL UNIT)
REMOVAL
1. Remove the negative battery cable from the battery.
2. Install a brake pedal prop rod.
3. Siphon the master cylinder.
4. Remove the primary brake line at the master cylinder.
5. Remove the primary brake line from the HCU (4).
6. Remove the secondary brake tube at the master cylinder.
7. Remove the secondary brake tube at the HCU (4).
8. Remove the 4 chassis lines (3) at the HCU (4).
9. Disconnect the HCU (4) electrical connectors (5).