Commander 4WD V8-4.7L VIN N (2006)
Yaw Rate Sensor: Service and Repair
SENSOR-DYNAMICS
REMOVAL
1. Remove the center console.
2. Disconnect electrical connector (3) from the dynamics sensor (1).
3. Remove the two nuts (2) securing the sensor to the floor.
4. Remove the sensors.
INSTALLATION
1. Install the dynamics sensor (1) to the vehicle.
2. Install the electrical connector (3)
3. Install the two retaining nuts (2) and tighten to 9 Nm (80 inch lbs.).
4. Install the floor console.
