Commander 4WD V8-4.7L VIN N (2006)
Cruise Control Servo: Service and Repair
SERVO-SPEED CONTROL
REMOVAL
The speed control servo assembly (3) is attached to a cross-support (4) located in the engine compartment.
1. Disconnect negative battery cable at battery.
2. Disconnect vacuum line at servo.
3. Disconnect electrical connector (5) at servo.
4. Remove servo mounting bolt (7).
5. Disconnect servo cable at throttle body.
6. Remove 2 mounting nuts (1) holding servo cable sleeve (4) to bracket.
7. Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip (3) and remove clip. Note: The servo
mounting bracket displayed is a typical bracket and may/may not be applicable to this model vehicle.
8. Remove servo (2) from mounting bracket. While removing, note orientation of servo to bracket.
INSTALLATION
