Commander 4WD V8-4.7L VIN N (2006)
Cruise Control Servo Cable: Service and Repair
CABLE-SPEED CONTROL
3.7L/4.7L
REMOVAL
1. Disconnect negative battery cable at battery.
2. Remove air intake tube at top of throttle body.
The accelerator cable must be partially removed to gain access to speed control cable.
3. Hold throttle in wide open position. While held in this position, slide throttle cable pin (1) from throttle body bellcrank.
4. Using a pick or small screwdriver, press release tab (2) to release plastic cable mount from bracket. Press on tab only enough to release cable from
bracket. If tab is pressed too much, it will be broken. Slide plastic mount (4) towards right side of vehicle to remove throttle cable from throttle
body bracket.
