Commander 4WD V8-4.7L VIN N (2006)
2. Position the oil pan gasket and pickup tube with new o-ring. Install the mounting bolt and nuts. Tighten bolt and nuts to 28 Nm (20 ft. lbs.).
3. Position the oil pan and install the mounting bolts. Tighten the mounting bolts to 15 Nm (11 ft. lbs.) in the sequence shown.
4. Lower the engine into mounts using special tool (1) # 8534.
5. Install both the left and right side engine mount through bolts (3). Tighten the nuts to 68 Nm (50 ft. lbs.).
6. Remove special tool # 8534.
7. Install structural dust cover.
8. Fill engine oil.
9. Reconnect the negative battery cable.
10. Start engine and check for leaks.
