Commander 4WD V8-4.7L VIN N (2006)
3. Install intake manifold retaining bolts and tighten in sequence shown in to 12 Nm (105 inch lbs.).
4. Install left and right radio suppressor straps.
5. Install throttle body assembly
6. Install throttle cable bracket.
7. Connect throttle cable and speed control cable to throttle body.
8. Install fuel rail.
9. Install ignition coil towers.
10. Install coolant temperature sensor.
11. Connect electrical connectors for the following components:
^
Manifold Absolute Pressure (MAP) Sensor
^
Intake Air Temperature (IAT) Sensor
^
Throttle Position (TPS) Sensor
^
Coolant Temperature (CTS) Sensor
^
Idle Air Control (IAC) Motor
^
Ignition coil towers
^
Fuel injectors
12. Install top oil dipstick tube retaining bolt and ground strap.
13. Install generator including electrical connections.
14. Connect Vapor purge hose, Brake booster hose, Speed control servo hose, Positive crankcase ventilation (PCV) hose.
15. Install air conditioning compressor including electrical connections.
16. Fill cooling system.
17. Install accessory drive belt.
18. Install air cleaner housing and throttle body resonator. Tighten resonator bolts 5 Nm (44 inch lbs.).
19. Connect negative cable to battery.
