Commander 4WD V8-4.7L VIN N (2006)
5.
Completely remove tar mastic patch from blower wheel if possible.
6.
Locate the base of the cowl stud that the mastic patch came from and install a piece of duct tape over it to seal against wind noise, (Fig. 1).
7.
If tar mastic patch or tar cannot be completely removed from blower wheel install a new blower motor assembly.
8.
Tighten the screws to 2.2 Nm (20 in.lbs.).
9.
Attach the blower motor wiring connector to the resistor/power module
10.
Install the silencer panel below the glove box.
11.
Install the glove box.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.