Commander 4WD V8-4.7L VIN N (2006)
Condenser HVAC: Description and Operation
CONDENSER-A/C
DESCRIPTION
The A/C condenser (1) is located in the front of the engine compartment behind the grille. The A/C condenser is a heat exchanger that allows the
high-pressure refrigerant gas being discharged by the A/C compressor to give up its heat to the air passing over the condenser fins, which causes the
refrigerant to cool and change to a liquid state.
The A/C condenser is equipped with an integral automatic transmission cooler and tapping block (2), mounting provisions for the power steering cooler
(3) and a tapping block for the A/C discharge line and the receiver/drier (4).
OPERATION
When air passes through the fins of the A/C condenser, the high-pressure refrigerant gas within the A/C condenser gives up its heat. The refrigerant then
condenses as it leaves the A/C condenser and becomes a high-pressure liquid. The volume of air flowing over the condenser fins is critical to the proper
cooling performance of the A/C system. Therefore, it is important that there are no objects placed in front of the radiator grille openings at the front of
the vehicle or foreign material on the condenser fins that might obstruct proper air flow. Also, any factory-installed air seals or shrouds must be properly
reinstalled following radiator or A/C condenser service.
The A/C condenser cannot be repaired and, if faulty or damaged, it must be replaced.
