Commander 4WD V8-4.7L VIN N (2006)
28.
Install the blower motor and connect the blower motor wire harness connector.
29.
Connect the negative battery cable.
30.
Start the engine.
31.
Raise all the windows to a slightly open position (about 1/2 inch opening).
32.
Set the blower to HIGH - A/C OFF.
33.
Set mode switch to PANEL OUTLETS.
34.
Set temperature switch to FULL HEAT.
35.
Set recirculation switch to RECIRCULATE.
36.
With the engine running, allow the blower to operate for 20 minutes.
37.
Turn the ignition switch to the OFF position.
38.
On AN/DN/HB/JR/LH/ND/PT/WG/WJ - vehicles (other vehicles proceed to the next step), raise the vehicle.
39.
Install the drain tube clamp/cap/plug.
40.
On AN/DN/HB/JR/LH/ND/PT/WG/WJ - vehicles (other vehicles proceed to the next step), lower the vehicle.
CAUTION:
Technician must use eye protection, rubber gloves, protective clothing, and avoid breathing vapors.
41.
Open all the windows in the vehicle.
42.
Disconnect and isolate the negative battery cable.
43.
Disconnect the blower motor wire harness connector and remove the blower motor.
44.
Shake an 8 ounce bottle of Cooling Coil Coating (p/n 04728942AB), and screw the bottle onto the applicator tool.
45.
Insert the applicator tool into the blower motor opening. Spray the full contents of the bottle on the cooling coil being carefully to cover the entire
surface of the cooling coil.
46.
Allow the vehicle to sit for 30 minutes.
47.
Install the blower motor and connect the blower motor wire harness connector.
48.
Connect the negative battery cable.
49.
On AN/DN/HB/JR/LH/ND/PT/WG/WJ - vehicles (other vehicles proceed to the next step), raise the vehicle.
CAUTION:
The excess cooling coil coating will drain when the cap/clamp/plug is removed in the next step.
50.
Remove the drain tube clamp/cap.
51.
On AN/DN/HB/JR/LH/PT/WG/WJ - vehicles (other vehicles proceed to the next step), lower the vehicle.
52.
Start the engine.
53.
Raise all the windows to a slightly open position (about 1/2 inch opening).
54.
Set the blower to HIGH - A/C OFF.
55.
Set mode switch to PANEL OUTLETS.
56.
Set temperature switch to FULL HEAT.
