Commander 4WD V8-4.7L VIN N (2006)
15.
Spray the full contents of water until the bottle is empty.
16.
Repeat Step #13 through Step #15 using the second bottle of water. When both bottles of water are empty, proceed to the next step.
17.
Install the joint duct.
18.
Disconnect the A/C clutch electrical connector at the A/C compressor.
19.
Start the engine.
20.
Set the blower to HIGH - A/C OFF.
21.
Set mode switch to PANEL OUTLETS.
22.
Set temperature switch to FULL HEAT.
23.
Set recirculation switch to RECIRCULATE.
24.
Open windows slightly (about 1/2 inch opening).
25.
With the engine running, allow the blower to operate for 20 minutes.
26.
Turn the engine off.
27.
Turn the ignition switch ON, do not start the engine, to allow blower motor operation.
28.
Fully open all windows.
29.
Remove the outer glove box and the inner glove box. Refer to the detailed service information available in TechCONNECT, under: Service Info,
23 - Body, 23C Body Interior, Instrument Panel
CAUTION:
Technician must use eye protection, rubber gloves, protective clothing, and avoid breathing vapors.
30.
Shake the 8 ounce bottle of Cooling Coil Coating (p/n 04728942AB), and screw the bottle onto the applicator tool.
31.
Insert the applicator tool into the recirculation inlet (behind glove box opening). Spray the full contents of the bottle in the airstream until the
bottle is empty.
32.
Start the engine.
33.
Set the blower to HIGH.
34.
Set the A/C switch to A/C OFF.
35.
Set mode switch to PANEL OUTLETS.
36.
Set temperature switch to FULL HEAT.
37.
Set recirculation switch to RECIRCULATE.
38.
Open windows slightly (about 1/2 inch opening).
39.
With the engine running, allow the blower to operate for 20 minutes.
40.
Turn the ignition switch to the off position.
41.
Fill the 4 ounce plastic bottle with warm water and screw onto applicator tool. Clean tool by spraying warm water under pressure into the shop
sink. Wipe the tool and store for next use.
42.
Connect the A/C compressor clutch electrical connector at the compressor.
43.
Open the right side panel outlet vent.
44.
Install inner glove box.
