Commander 4WD V8-4.7L VIN N (2006)
2. Install the upper defrost/panel-air door (1), lower defrost/panel-air door (2), directional vane (3), rear outlet-air door (4) and the blend-air door (5)
into the right side air distribution housing (6) as required. Align the air doors with the pivot shaft holes in the housing.
3. If removed, align the front floor-air doors (1 and 3) with each other and install then into the center partition (2). Make sure that the air door
retaining tabs (4) are fully engaged.
4. Install the center partition (3) into the right half of the air distribution housing (2).
5. Install the left half of the air distribution housing (1) onto the right half of the air distribution housing. Align the air door pivot shafts with each
other and with the pivot shaft holes in the housing.