Commander 4WD V8-4.7L VIN N (2006)
align the splines on the actuator output shaft with those on the floor/console door pivot shaft.
12. Install the screws (1) that secure the rear floor/ console door actuator onto the right side of the air distribution housing. Tighten the screws to 2
N.m (17 in. lbs.).
13. If equipped with dual zone heating-A/C, position the blend door actuator mounting bracket (5) onto the right side of the air distribution housing
and install the retaining screws (4). Tighten the screws to 2 N.m (17 in. lbs.).
14. If equipped with dual zone heating-A/C, position the blend door actuator (7) onto the blend door actuator mounting bracket and install the
retaining screws (6). Tighten the screws to 2 N.m (17 in. lbs.). If necessary, rotate the actuator slightly to align the splines on the actuator output
shaft with those on the blend door stop.
15. On RHD models, carefully install the heater core into the left side of the air distribution housing (3).
16. Install the front floor door linkage rod (6) and the lower defrost/panel door pivot gear (2) onto the left side of the air distribution housing.
NOTE: Align the arrow on the lower defrost/panel door pivot gear with the locator in the window of the mode door cam during installation of the
mode door cam.
17. Align and install the mode door cam (7) onto the left side of the air distribution housing.
NOTE: Align the guide pin on the upper defrost/ panel door linkage rod with the guides in the mode door cam during installation of the upper
defrost/panel door linkage rod.
18. Align and install the upper defrost/panel door linkage rod (8) onto the left side of the air distribution housing.
NOTE: Align the detent in the upper defrost/panel door pivot gear with the locator in the upper defrost/panel door linkage rod during installation
of the upper defrost/panel door pivot gear.
19. Align and install the blend door stop (5), front floor door pivot gear (4) and the upper defrost/panel door pivot gear (1) onto the left side of the air
distribution housing.
