Commander 4WD V8-4.7L VIN N (2006)
17. Install the air inlet housing (2) onto the HVAC housing (1).
18. Install the air distribution housing (3) onto the HVAC housing.
19. Install the HVAC housing assembly.
Rear
HOUSING-HVAC
DISASSEMBLY
NOTE: The rear HVAC housing must be removed from the vehicle for service of the mode door actuator, blend door actuator, blower motor and
blower motor resistor and, it must be disassembled for service of the A/C evaporator, heater core, mode-air door and blend-air door.
1. Remove the rear HVAC housing and place it on a workbench.
2. Carefully remove the foam seal (1) from the flange (2) located at the bottom of the rear HVAC housing (3). If the seal is deformed or damaged, it
must be replaced.
3. Partially bend the inner half of the flange downward and remove the heater core tubes (4) from the flange.
