Commander 4WD V8-4.7L VIN N (2006)
Seat Belt Reminder Lamp: Service and Repair
Customer Programming Sequence
CUSTOMER PROGRAMMING SEQUENCE
NOTE: The following sequence of events must occur within 60 seconds of the ignition switch being placed in the ON position in order for the
programming to be completed successfully. Even if the vehicle is equipped with both driver and passenger side front seat belt switches, this
programming sequence MUST be performed using the driver side front seat belt. The passenger side front seat belt switch has no programming
functionality.
1. With all doors closed and the ignition switch in any position except ON or START, buckle the driver side front seat belt.
2. Turn the ignition switch to the ON position and wait for the seatbelt indicator reminder function to conclude (about six seconds).
3. Unbuckle and buckle the driver side front seat belt three or more times, ending with the belt buckled.
4. Turn the ignition switch to any position except ON or START to toggle the beltminder feature from its current setting (from active to inactive, or
from inactive to active). A single chime tone will provide an audible confirmation that the programming sequence has been successfully
completed.
