Commander 4WD V8-4.7L VIN N (2006)
Headlamp Bulb: Service and Repair
Bulb - Headlamp
FRONT LAMP UNIT
BULB - HEADLAMP
NOTE: The following procedure applies to both the low beam (upper) and the high beam (lower) headlamp bulbs. The service procedures for each bulb
are the same, only the bulb location, size and type differ.
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will
result.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the cover from over the top of the front lamp unit.
3. Disconnect the pigtail wire connector from the connector receptacle integral to the low beam (upper) or high beam (lower) bulb base (1) on the
back of the front lamp unit housing.
4. Firmly grasp the bulb base and rotate it counterclockwise about 30 degrees to unlock it.
5. Pull the bulb and base straight out from the keyed opening in the reflector.
INSTALLATION
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the
socket and/or the lamp wiring.
1. Align the low beam (upper) or high beam (lower) bulb base (1) with the keyed opening on the back of the reflector.
