Commander 4WD V8-4.7L VIN N (2006)
1. Position the A/C liquid line (1) into the engine compartment.
2. Remove the tape or plugs from the opened liquid and suction line fittings and the receiver/drier and expansion valve ports.
3. Lubricate a new O-ring seal with clean refrigerant oil and install it onto the rear liquid line fitting. Use only the specified seal as it is made of a
special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
4. Connect the A/C liquid line to the A/C expansion valve (2) and engage the two liquid line retainer clips (4) to the frame rail (3).
5. Lubricate a new dual plane seal with clean refrigerant oil and install it onto the front liquid line fitting. Use only the specified seal as it is made of a
special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
6. Connect the A/C liquid line (2) to the receiver/drier (3).
7. Install the nut (1) that secures the A/C liquid line to the receiver/drier. Tighten the nut to 20 N.m (15 ft. lbs.).
NOTE: LHD model with 5.7L engine shown in illustration. RHD model and other engines similar.
