Commander 4WD V8-4.7L VIN N (2006)
Power Steering Line/Hose: Service and Repair
Pressure Hose - Gear to Pump
PRESSURE HOSE - GEAR TO PUMP
REMOVAL
1. Siphon the power steering fluid from the reservoir.
2. Disconnect the pressure line (2) at the pump (1).
3. Disconnect the pressure line (2) at the gear (7).
4. Remove the three mounting brackets (6) for the pressure line at the engine cradle.
5. Remove the pressure line (2) from the vehicle.
INSTALLATION
1. Install the line (2) to the vehicle.
2. Install the three mounting brackets (6) for the pressure line (2) to the engine cradle.
3. Reconnect the power steering pressure line (2) to the power steering gear (7) Tighten to 28 Nm (21 ft. lbs.).
4. Reconnect the power steering pressure line (2) to the power steering pump (1) Tighten to 28 Nm (21 ft. lbs.).
5. Refill the power steering fluid and bleed the system.